If the file runs through some warmup days, add reporting during warmup and Output:Variable,*,System Node Temp to see what is happening. Add node names for specific plant loop nodes (the * in Output:Variable object) to see only a few temperatures. Output:Diagnostics,ReportDuringWarmup; On 3/23/2012 10:46 AM, Vinay Devanathan wrote: I was previously using a HeaderedPumps object, I removed it and used a regular single Pump object and the error was removed. Probably I did not specify the HeaderedPumps object properly? Maybe it transferring too much heat to the fluid because of unusually high power? -- Richard A. Raustad Senior Research Engineer Florida Solar Energy Center University of Central Florida 1679 Clearlake Road Cocoa, FL 32922-5703 Phone: (321) 638-1454 Fax: (321) 638-1439 or 1010 Visit our web site at: http://www.fsec.ucf.edu UCF - From Promise to Prominence: Celebrating 40 Years __._,_.___ Primary EnergyPlus support is found at: http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx The primary EnergyPlus web site is found at: http://www.energyplus.gov The group web site is: http://groups.yahoo.com/group/EnergyPlus_Support/ Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files. EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required) Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe __,_._,___ |