[EnergyPlus_Support] DX coil problem

[Eshagh <isac_moh@xxxxxxxxx>]

Hi,

I would be happy if someone helps me with the following issue.

I use system 6 for my baseline simulation in weather 1b which is hot climate . The AHU consists of  Outdoor air mixer, variable fan, electric heating coil and DX cooling coil. I ran the simulation and the flow rates are fine (the OA and maximum flow rate). However, I have problem with the DX coil. I think the coil can not cool down air temperature enough to satisfy my set point temperature that is 14C. The profile before and after cooling coil has about 14-15C temperature difference with a special pattern. The temperature should be constant (14C) but it cools down and keeps it pattern like before the cooling coil. I just noticed that when I turn off the out door air (OA), the temperature becomes constant (14C) and it's fine. However when I add the outdoor air flow rate (about 46C in July) again, the cooling coil cools down but as I mentioned, again it does not cool down to 14C. Could anyone please let me know what else I can check for solving this problem? Can the cooling curves cause the problem?

Thanks,

Eshagh

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___