Re: [EnergyPlus_Support] infiltration-nat. ventilation

[Thodwris Xaritidis <maki_to_fai@xxxxxxxxx>]

Hello again,

In the building that I am simulating I ve been given a value

for infiltration and one for nat vent for the whole building.

Is there any option to e+ to apply the total infiltration/ vent. portion automatically in the whole construction?

Or else how can I be sure which are the correct values for each zone?

thank you

---

From: FrancescoP <direzionecontraria@xxxxxxxx>
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Sent: Sunday, 3 June 2012, 10:43
Subject: [EnergyPlus_Support] Re: GetSpecificHeatGlycol: Temperature is out of range

 

I have the same problem:

sometimes the temperature is too low

************* ** Warning ** GetSpecificHeatGlycol: Temperature out of range (too low) for fluid specific heat
************* ** ~~~ ** This error occurred 58225 total times;
************* ** ~~~ ** during Warmup 0 times;
************* ** ~~~ ** during Sizing 0 times.
************* ** ~~~ ** Max=-9.894200E-003 {C} Min=-11.665963 {C}

and sometimes (actually, a lot of times...) it is too high

************* ** Warning ** GetSpecificHeatGlycol: Temperature out of range (too high) for fluid specific heat
************* ** ~~~ ** This error occurred 3949461 total times;
************* ** ~~~ ** during Warmup 0 times;
************* ** ~~~ ** during Sizing 0 times.
************* ** ~~~ ** Max=277.409112 {C} Min=125.000118 {C}

Any suggestion?
Best Regards

--- In EnergyPlus_Support@xxxxxxxxxxxxxxx, Omar Tabuyo <omartabuyo@...> wrote:
>
> Dear all,
>
> Anyone knows how i could solve this warnning? I have checked all system nodes temperature and there is not any node which temperature is upper 85ºC
>
>    ** Warning ** GetSpecificHeatGlycol: Temperature is out of range (too high) for fluid specific heat **
>    **   ~~~   ** ..Called From:UpdateSolarCollector Fluid name =WATER,Temperature=129.79
>    **   ~~~   **  Environment=RUN PERIOD, at Simulation time=01/06 12:15 - 12:30
>
> Do this warnning modify the simulation results? 
>
> What is the warnning meaning?
>
> Thanks
>

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___