This document may contain valuable information proprietary to CleanTech Analytics which is private and confidential. It may not be shared, copied, stored or transmitted in any form without the prior written consent of CleanTech Analytics
Hi all,
I'm working on a leed simulation project, and I get this model basically finished, I was just checking some inputs and curves. When, last week, i downloaded and installed the new 7.1 energy plus version, at this time i ran a already simulated file, just to see any difference, and i got a lot of set point not met during occupied hours. The strange thing, it is the same free errors working file. Does anybody had an experience like that?
Some plus information
- the geometry was exported from Design Builder
- the HVAC system is a VRF heat pump
- all the HVAC components are sized, after the conversion I checked, they are all the same size
- I already checked all the schedules, and people, illumination, equipment gains
- the climatic file is the same
- the only difference i can recall is that i simulated the file with two different versions of the enegyplus
I will appreciate any help,
Gustavo
__._,_.___
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___