[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] system sizing not reported
Is this the WAHP Equation fit or Parameter Estimation model? What version of EnergyPlus are you using?
Though it implies that the Parameter Estimation model can be autosized, it is incorrect. Corrected in the current beta and upcoming V8 release. 

On 2013-03-23 15:52, Mark wrote:

Hi

I have a Water/air heat pump simulation based on a Trane WHSP.  The
simulation runs fine however the ssz spreadsheet does not show and is
greyed out as a single selection - any ideas?  I ran a similar with an
air/air heat pump and it showed up, copied the report across but still
nothing.

Mark