[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] Modeling with District Cooling

Dear Forum,

I am modeling a CAV dual duct system that uses District Cooling as a cooling source. I have two models, since the project is for LEED Certification. The proposed design appears to work correctly but for the baseline design the district cooling rate increases more than 40% compared to the proposed, but there is no real reason for that. I also get a high number of hours where the cooling set-point is not met, and almost all of the values are in auto-sized.

Any help or comments would be greatly appreciated.


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:

The group web site is:

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID required)

<*> To change settings via email:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo! Groups is subject to: