Dear Anant,
If your energy simulation works without errors and the zone temperature is not very close to the setpoint, the cooling (or heating) capacity may be too small for the zone.
James V Dirkes II, PE, BEMP, LEED AP
www.buildingperformanceteam.com
Energy Analysis, Commissioning & Training Services
1631 Acacia Drive, Grand Rapids, MI 49504 USA
616 450 8653
From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx] On Behalf Of energy.anant
Sent: Friday, June 07, 2013 5:48 PM
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: [EnergyPlus_Support] Re: Help: Inverter AC modeling
I am trying to model the inverter AC which is a Veritable refrigerant flow system. To achieve this i have used following class objects Cooling coil: DX:VRF, HVAC Template: Terminal Unit : VRF, Air conditioner : VRF and a constant volume fan.
there is no outdoor air system.
What i suspect is that the problem may be with cooling capacity curves though i am not sure that my
Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are currently allowed but be mindful that not everyone has a high speed connection. Limit attachments to small files.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___