[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support] Infiltration input





Are you talking about a ZoneGroup in DesignBuilder or a ZoneGroup in EnergyPlus?

I know nothing about DesignBuilder (or almost nothing).

There is a "global" setting where a (for example) Infiltration object will use a global list and apply it to all the zones.  That's a ZoneGroup in EnergyPlus.

Each zone would be calculated individually -- (basically, the global list expands into individual infiltration statements for each zone).

You can check the .eio file for specifics for each infiltration.


At 02:20 PM 8/30/2013, George Georgiou wrote:


Let's say that I am using the Flow/Exterior WallArea which requires a single value. If I use the zonegroup field to combine all the zones together, the value will be multiplied with each zone ?

Again thank you very much for the comments.




__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___