[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [EnergyPlus_Support] Node connection error



Hello，

Happy new year! Hopefully you have come back to work.

The problem statement is at the bottom of this mail, and  I will be grateful if you can give me some clues to solve my problem in the Energyplus. Thanks a lot!

Regards

 

Best Regards

Wenke Fan

-----------------------------

Wenke Fan

PhD Candidate - Sustainable Building Research Center (SBRC)

Innovation Campus, University of Wollongong, NSW, 2522

M + 61 406 144 431

W http://sbrc.uow.edu.au

 

email signature image

 

University of Wollongong CRICOS: 00102E

Please consider the environment before printing this email.

 

 

 

 

 

 

From: EnergyPlus_Support@xxxxxxxxxxxxxxx [mailto:EnergyPlus_Support@xxxxxxxxxxxxxxx]
Sent: Saturday, 23 December 2017 3:26
To: EnergyPlus_Support@xxxxxxxxxxxxxxx
Subject: Re: [EnergyPlus_Support] Node connection error

 

 

Mmm...this is not trnsys. When I started learning e+, it took me a long time to figure out the rules for loops. I'm out of office till 3 Jan, but if you remind me then, I'll mail over a good graphic to help.

 

Am 20.12.2017 1:41 nachm. schrieb "wf303@xxxxxxxxxxxxxx [EnergyPlus_Support]" <EnergyPlus_Support@xxxxxxxxxxxxxxx>:

 

ello everyone, i am currently testing and modifiying the Energyplus example file. The model i am using is 'DesiccantCVRh.idf' in the example folder. The original model works well and i made some modification on the secondary air flow of the HeatExchanger. The original model uses the relief air as the inlet of the Secondary air flow, but i want to use the outside air as the inlet air to cool down the primary air flow. To do so, i disconnect the relief air and inlet side of the secondary air flow of heat exchanger. Instead, i created an Outside Air Inlet Node4 and Fan and link these two new objects to the inlet side of the secondary air flow of Heat exchanger. After running the simulation, i found the the air temperature of primary air flow at the inlet and outlet of Heat exchanger is equal and the air mass flow rate at the Outside Air Node4 (inlet node of the secondary air flow) was zero. The modified system is shown below where the main air loop branch include the Outdoor air system, supply fan and cooling coil.

I checked the error report and found the relevant warning information about the outside air node4, just showing below:

It says the connection of the outside air node is not correct. In my model, i just creasted a outdoor node list and put this outside air node on the list and i have nothing operation of this node on other place. So can anyone give me some idea on this issue, many thanks!

 



__._,_.___
Posted by: Wenke Fan <wf303@xxxxxxxxxxxxxx>


EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The EnergyPlus web site is found at:
http://www.energyplus.net/

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the &quot;search&quot; button.




__,_._,___