[Equest-users] DOAS Dummy Warnings - no problem?

[Jacob Goodman]

I saw your question on the warnings from your DOAS model and didn't see 
any replies. I have some of those same warnings.

 **WARNING**********************************************************************
             EL1 Sys1 (PVVT) (G.SW1)          has a MIN-AIR-SCH, OA-CONTROL
             other than FIXED and/or a MIN-OA-METHOD other than 
FRACTION-OF-DESIGN
             along with having a specified OA-FROM-SYSTEM. This may 
cause incorrect
             OA load/flow calculation for its OA-FROM-SYSTEM.

Shows up for each zone the DOAS is supplying and so does:


 **WARNING**********************************************************************
             SYSTEM EL1 Sys1 (PVVT) (T.C12)          has zero outside 
air for design calculations

the second one seems normal since I put 0 cfm OA in the DD wiz before I 
went to detailed edit mode, but I'm not sure about the first one.

Hope your model turned out well, for both of our sakes.

Thanks,
-- 

Jacob Goodman , LEED AP, Green Building Specialist
v:509.747.2179  f:509.747.2186  i:www.lseng.com <http://www.lseng.com>
L&S  Engineering Associates, Inc.
'High Performance Design'
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20091218/1d45702e/attachment.htm>