[Equest-users] First time modeling cooling towers, Need Help! :)
Kevin Felt
KevinFelt at magrann.com
Fri Feb 27 12:04:32 PST 2009
I am trying to model water source heat pumps attached to a loop
consisting of a cooling tower and boiler.
I have a few of questions:
How do I do this the right way? The EER of the heat pumps is quite a
bit better than baseline, but my cooling use came out higher.
1. I assigned the boiler to the same loop as the cooling tower,
but cannot assign that loop to the heating side of the heat pumps. Do I
have to have the boilers on a separate HW loop?
2. Under the Cooling tower on the "Fluid and Dry Coolers" tab
under operation is "Heat Exchanger". Do I have to specify the heat
exchanger in order for the cooling tower to operate properly or is
filling in the Basic Specifications enough?
3. If I specify the heat exchanger, how do I know which to pick?
I have a cooling tower that has water running over the pipes that
contain the fluid I am trying to cool that also has a fan to promote
evaporative cooling. Is this air to water, water to air, water to
water?
4. I don't know where to put the size of the electric heater for
Pan Freeze Protection, all I could see is where I picked electric.
Any help will be appreciated.
Kevin A. Felt
Kevin A. Felt
Senior Technical Analyst
QA Designee
MaGrann Associates
856-722-9799
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20090227/2d2bd7c7/attachment.htm>
More information about the Equest-users
mailing list