[Equest-users] Discharge Air Reset Schedule

[Paul Diglio]

I am modeling an air handler with a chilled water coil.  I want to reset the discharge air temperature based on OAT.  I set the Cool Control to to Warmest, Reset Priority to Airflow First then Maximum Cool Reset T to 75 and Minimum Cool Reset T to 52.

The program ran the simulation with no errors.  When I re-open the project after saving and closing it, the above setting are gone and I have to enter them again.

Am I doing something wrong?  I tried it both in DD Wizard and Detailed Interface.

I also tried setting the Cool Control to Reset, Reset Priority to Temperature First and entered an Annual DAT Reset Schedule.  Still would not keep these setting after saving and opening the project.

Thank you,

Paul Diglio, CEM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20100228/0371897c/attachment.htm>