[Equest-users] Wall heights were wrong can I lower the roof?

[Carol Gardner]

Are you in the Detailed Edit mode? If you are click on your building shell
tab and then go into the spaces where your roof is and set your z to
whatever height you need your roof to be at. Similarly you can adjust your
wall heights if you need to by clicking on them and changing the height.

Carol

On Wed, Jul 6, 2011 at 3:28 PM, <tblack_pe at cox.net> wrote:

> I was creating a model of a church with a cathedral ceiling and must have
> missed the input to show the walls are only 10 feet.  Can I lower the roof,
> or do I simply need to re-create the roof?
>
> Best regards,
>
> Tracy A. Black, P.E.; LEED AP
> 5002 E Redfield Road
> Scottsdale, AZ 85254-2848
> h:  602-569-8347
> c:  602-332-7197
> tblack_pe at cox.net
> http://www.linkedin.com/in/**tblackpeleedap<http://www.linkedin.com/in/tblackpeleedap>
> ______________________________**_________________
> Equest-users mailing list
> http://lists.onebuilding.org/**listinfo.cgi/equest-users-**onebuilding.org<http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org>
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE@**ONEBUILDING.ORG<EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG>
>



-- 
Carol Gardner PE
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20110706/481cbecb/attachment-0002.htm>