[Equest-users] Cooling Sizing Ratio & Unmet Load hours

[RIAD ABED]

Dear All e-Quest Users

Please If someone can help :
 
1- for Sizing Ratio : 1.15 (for Cooling – Equipment Efficiencies) , it should applied be for Baseline Model only ? or also it should be in Proposed Model ?
2- for Umnet Load Hours it should be under 300 Hours for Each Room/Zone ? or For the Total Building ? & where I can find the Umet Load Hours in e-Quest simulation Report
 
Thanks by Advance for all of u …….
 
My Regards,
Riad el Abed
Chief MEP , LEED GA,PQP
ASHRAE MEMBER
Tel  +96170 643977
www.riadabed.com
 
DEC Consultants
Po Box 26330
Abu Dhabi
Tel +9712 4457505
Fax +9712 4457506
www.dec.ae
_____________________________________________________________________ 
DISCLAIMER
This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error please notify the sender. Please note that any views or opinions presented in this email are solely those of the author and do not necessarily represent those of DEC Consultants. Finally, although efforts were made to prevent virus transmission, the recipient should check this email and any attachments for the presence of viruses. DEC Consultants accepts no liability for any damage caused by any virus transmitted by this email. 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20120216/04e43401/attachment.htm>