[Equest-users] Fuel Metering
Brian Fountain
bfountain at greensim.com
Tue Jun 26 07:20:16 PDT 2012
Then it would seem you are modelling the boiler loading (lead - lag) rather
than the building loading. If you wish to isolate the buildings, I think
you need 3 hot water loops. If you wish, they could be secondary loops
feeding off a common primary loop, that way you would not have to dedicate
boilers to the individual buildings but you could look at the heating loads
for the secondary loops on the PS-H reports to see what their heating loads
are like.
Hope this helps.
Brian
-----Original Message-----
From: Samantha MacHardy [mailto:SMacHardy at pemi.com]
Sent: Tuesday, June 26, 2012 10:16 AM
To: 'bfountain at greensim.com'
Subject: RE: [Equest-users] Fuel Metering
No, each is fed off of the same loop in the model.
-----Original Message-----
From: bfountain at greensim.com [mailto:bfountain at greensim.com]
Sent: Tuesday, June 26, 2012 10:03 AM
To: Samantha MacHardy
Subject: Re: [Equest-users] Fuel Metering
Are there separate hot water loops for the 3 buildings?
Brian Fountain
bfountain at greensim.com
-----Original Message-----
From: Samantha MacHardy <SMacHardy at pemi.com>
Sender: equest-users-bounces at lists.onebuilding.org
Date: Tue, 26 Jun 2012 09:11:11
To: 'equest-users at lists.onebuilding.org'<equest-users at lists.onebuilding.org>
Subject: [Equest-users] Fuel Metering
_______________________________________________
Equest-users mailing list
http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
To unsubscribe from this mailing list send a blank message to
EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
More information about the Equest-users
mailing list