[Equest-users] building floor area in LS-C report is stuck

[Keith Swartz]

Christian,

The area entered in the wizard is used to calculate dimensions of the pre-defined shapes. If you changed any of those dimensions (X and Y lengths) or traced a custom outline in Screen 2, then that overrides the overall area entered on Screen 1.

Keith Swartz, PE, BEMP, LEED AP
Senior Energy Engineer | Energy Center of Wisconsin | Madison.Chicago.Minneapolis
608.210.7123 | www.ecw.org<http://www.ecw.org/>

From: Christian Stalberg [mailto:cstalberg at naturalintelligence.us]
Sent: Wednesday, June 12, 2013 5:59 PM
To: equest-users at lists.onebuilding.org
Subject: [Equest-users] building floor area in LS-C report is stuck

This is a new one for me. In wizard mode no matter what I do to change the floor area in the model (alter # floors, X and Y lengths, etc.), the LS-C report is stuck on 120,000 sf.

Has anyone seen this before?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130614/5610bcbf/attachment-0002.htm>