[Equest-users] help

[Amruta Khanolkar]

Hi Ritu,

eQuest uses floor multipliers for the middle floors to optimize the
simulation time. So if you go to the "General Shell Information" i.e the
1st screen in the Wizard mode and uncheck the "use floor multiplier" box
you should be able to see all the floors.

Thanks,
Amruta
-----

*Amruta Khanolkar*
Mechanical Engineering
……………………………………………………

*SmithGroupJJR*
Arizona Center, 455 North Third St., Suite 250
Phoenix, AZ 85004
*
**t* 602.265.2200 <#> *d* 602.824.5273 <#> *f* 734.780.8787 <#>

Amruta.Khanolkar at smithgroupjjr.com



Ranked #1 for design quality and #2
overall<http://viewer.zmags.com/publication/9c2fc07c#/9c2fc07c/1> by
*Architect*,

the magazine of the American Institute of Architects and

recipient of the 2011 Landscape Architecture Firm Award
<http://www.asla.org/AwardRecipient.aspx?id=32408>

from the American Society of Landscape Architects.
<http://www.asla.org/AwardRecipient.aspx?id=32408>



Connect <http://www.smithgroup.com/?id=6> with us! www.smithgroupjjr.com


On Wed, May 22, 2013 at 7:25 AM, ritu garg <engg_ritz at yahoo.co.in> wrote:

> sir i am having four storied building but when importing seeing only 1st
> 2nd and fourth floor third is not visible
>
> _______________________________________________
> Equest-users mailing list
> http://lists.onebuilding.org/listinfo.cgi/equest-users-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> EQUEST-USERS-UNSUBSCRIBE at ONEBUILDING.ORG
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20130522/f86f1597/attachment-0002.htm>