[Equest-users] A question about modeling Powered Induction Units in

[Grando, John]

It would help to get the BEPS/BEPU/PSE reports to see where the decrease is coming from.  However, there are a few standard things that lead to this problem.  You may want to check that if you have any SET-DEFAULTS defined for VAV, they will not apply to the PIU system when you switch over so you should check the actual model files for each run to make sure the inputs are the same.  You can easily do this by taking the parametric .inp and saving it as a different file and opening it.

John Grando BEMP | CEM | LEED AP BD+C | Associate
Phone: 212-615-3705 | Fax: 212-615-3700
jgrando at cosentini.com

Cosentini Associates - A Tetra Tech Company
Two Pennsylvania Plaza - Third Floor - New York, NY 10121
www.cosentini.com<http://www.cosentini.com/>




NOTICE OF CONFIDENTIALITY

This E-mail message and its attachments (if any) are intended solely for the use of the addressees hereof.  In addition, this message and the attachments (if any) may contain information that is confidential, privileged and exempt from disclosure under applicable law.  If you are not the intended recipient of this message, you are prohibited from reading, disclosing, reproducing, distributing, disseminating or otherwise using this transmission.  Delivery of this message to any person other than the intended recipient is not intended to waive any right or privilege.  If you have received this message in error, please promptly notify the sender by reply E-mail and immediately delete this message from your system.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/equest-users-onebuilding.org/attachments/20140220/4ad1b8ed/attachment.htm>