[BLDG-SIM] Modelling of a domed roof?
Mike Tillou
miket at etcgrp.com
Mon Jul 25 08:21:38 PDT 2005
Brian,
Within DOE2.2/equest you can also create triangular wall shapes that
could be used to create your dome.
Mike
Michael Tillou, PE
etc Group, Inc.
PO Box 7, Williamstown, MA 01267
ph. (413) 458-9870 fx. (413) 458-9875
www.etcgrp.com
-----Original Message-----
From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of Jason
Glazer
Sent: Monday, July 25, 2005 9:54 AM
To: BLDG-SIM at gard.com
Subject: [BLDG-SIM] Modelling of a domed roof?
Brian,
An interesting question. I've never modeled a dome so this
is based on intuition.
If you are thinking about comparing different dome
insulation levels, dome shapes, etc.., then I would be
careful and have a surface for every difference of 10 to 30
degrees (this adds up to a lot of surfaces).
On the other hand, if the dome will not change between
simulation permutations, I would probably just use nine
surfaces: eight each 45 degrees from one another around the
dome each tilted 45 degrees and another flat one on top.
Remember, in the model these surfaces can be square as long
as the areas add up to the correct total area and they
don't cast shadows on each other.
Jason
On 25 Jul 2005 at 9:30, Brian Fountain wrote:
> I am developing a DOE-2 model in eQUEST for a building with
> a large domed roof. Does anyone have any suggestions for
> approximating roof geometry - i.e. how many facets should I use for
> reasonable solar gain & conduction results?
>
>
>
> Any help is appreciated.
>
>
>
> Regards,
>
> Brian
>
>
>
> ______________________
>
> Brian Fountain, P.Eng.
> Energy Engineer
> GreenSim
> Burlington, ON, Canada
> (905)639-6014 -- voice
> (905)639-0443 -- fax
> bfountain at greensim.com
=========================================================
Jason Glazer, P.E. jglazer AT gard DOT com 847 698 5686
GARD Analytics - http://www.gard.com/
1028 Busse Highway, Park Ridge, IL 60068
Building Energy Simulation and Analysis
Admin of BLDG-SIM list for building simulation users
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list