[bldg-sim] VisualDOE 4.0 geothermal modeling
Joe Llona
jllona at cdiengineers.com
Fri Sep 30 10:11:49 PDT 2005
What wound up working was changing the low-safety loop temperature from
45 to 40. Increasing the flow rate per ton would have helped also.
________________________________
From: bldg-sim at gard.com [mailto:bldg-sim at gard.com] On Behalf Of
Dawne Herrick
Sent: Friday, September 30, 2005 9:09 AM
To: bldg-sim at gard.com
Cc: Leslie Jonsson
Subject: [bldg-sim] VisualDOE 4.0 geothermal modeling
VisualDOE will not let me define any supplemental heating for my
ground source heat pump system. Thus, I have unmet heating loads. Any
suggestions?
~Dawne Herrick, PE
CDi ENGINEERS
(425) 672-1071
www.cdiengineers.com <file://www.cdiengineers.com>
TAKE NOTICE - CDi is moving!
Effective October 10, 2005, CDi's address is:
4200 194th St SW, Suite 200, Lynnwood, WA 98036
Phone, fax, and e-mail remain the same.
==================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20050930/2885d8bf/attachment-0002.htm>
More information about the Bldg-sim
mailing list