[bldg-sim] 2 Circulation Loops with TES
Tupper, Kendra
Kendra.Tupper at sf.fk.com
Wed Feb 15 15:04:02 PST 2006
I am trying to simulate a TES system that is charged by one dedicated
chiller (and attached chilled water circulation loop) and discharges to
the main chilled water loop, which is attached to the cooling coils.
When the simulation proceeds past load calcs, I get the following error:
Loop: Circulation Loop 5 has zero design flow. Check input for
consistency, or specify design loads.
Circulation loop 5 refers to my dedicated chilled water loop that is
served by a small chiller and charges my TES system. The TES system is
the load on this loop, so that load should cause a design flow.
Has anyone encountered a similar problem?
Thank you!
Kendra Tupper
FLACK + KURTZ
405 Howard Street 415.398.3833 Main
Suite 500 415.402.5840 Direct
San Francisco, CA 94105 415.433.5311 Fax
http://www.flackandkurtz.com kendra.tupper at sf.fk.com
This e-mail may contain confidential and/or privileged information.
If you are not the intended recipient (or have received this e-mail in
error)
please notify the sender immediately and destroy this e-mail.
Any unauthorized copying, disclosure or distribution of the material
in this e-mail is strictly forbidden.
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20060215/e02b7d1c/attachment.htm>
More information about the Bldg-sim
mailing list