[BLDG-SIM] dehumidification using cooling coil in equest
Rohini Brahme
rbrahme at harc.edu
Wed Jun 21 13:46:42 PDT 2006
I am trying to simulate UF system and use only cooling coil for
dehumidification (max 50%)- but without much success. (climate is
houston - not sure if just cooling coil will even work)
Here is what I am doing:
Run a case with min-supply-temp set at 62F - get the supply cfm.
Run the next case with above supply cfm's, and min-supply-t at 53
F(error if I go below this number), cold deck temp at 62, increase in
supply temp due to duct gains - 2F (I have done the other stuff like
some part of internal loads in the plenum etc.)
The SS-N report shows that the humidity is between 60-69% for majority
of the hours.
Are their any other variables that I need to change? Any suggestions are
highly appreciated.
Thanks
Rohini
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list