[BLDG-SIM] Condensor hot gas for reheat

Rohini Brahme rbrahme at harc.edu
Tue Mar 27 12:26:16 PDT 2007


I found the following in the help file. Cannot locate the MAX-COND-RCVRY
keyword - any ideas where I should search for it in equest - or can I
just add it in the input file and it will work? Any thoughts
appreciated. Thanks
- Rohini

Additional capabilities for PSZ system:


3.    To enable control of maximum humidity and use compressor superheat
for reheat, insert MAXIMUM-HUMIDITY (60% is allowed) and also
MAX-COND-RCVRY (0.5 is typical) in the SYSTEM keyword list. Note that
REHEAT-DELTA-T must also be specified.  [12]

 
-----Original Message-----
From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of Rohini
Brahme
Sent: Tuesday, March 27, 2007 1:40 PM
To: BLDG-SIM at gard.com
Subject: [BLDG-SIM] Condensor hot gas for reheat



	Hi All:
	 
	I am simulating a RTU in equest - it uses hot gas from the
condensor for dehumidification reheat. Any ideas on how I can do this in
equest?
	 
	Thanks
	- Rohini
	
	==================
	You received this e-mail because you are subscribed 
	to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
	from this mailing list send a blank message to 
	BLDG-SIM-UNSUBSCRIBE at GARD.COM



===========================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20070327/089738be/attachment-0002.htm>


More information about the Bldg-sim mailing list