[BLDG-SIM] DOE 2.1E Hourly Report Question

[Eben Twombly, PE]

Jon - You also have to add the last line shown in the appropriate section
(Loads, Systems, etc) of standard report section:

SYSTEMS-REPORT  
   VERIFICATION     = ( ALL-VERIFICATION )
   SUMMARY          = ( ALL-SUMMARY )
   HOURLY-DATA-SAVE = FORMATTED
   ..

If HOURLY-DATA-SAVE is not specified, the default is NO-SAVE

--Eben

-----Original Message-----
From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of Jon Evans
Sent: Wednesday, November 14, 2007 7:15 AM
To: BLDG-SIM at gard.com
Subject: [BLDG-SIM] DOE 2.1E Hourly Report Question

I added the following code to a DOE 2.1E file to obtain the hourly electric
(32) and gas consumption (45).  The code was added in the systems block.

Where is the hourly report exported to? I was under the impression that it
goes to the .sim file and would be called RB-1, but when I open that file it
doesn't show up (the .sim file also gives me an out of memory message- could
this be causing the problem?).  Thanks for any insight in advance.

$=======================================$
$       Hourly Report Information
$=======================================$
S-1 = SCHEDULE 
THRU DEC 31 (ALL) (1,24) VALUES = (1.) ..

RB-1 = 	REPORT-BLOCK
	VARIABLE-TYPE = Alternate_1_RTU
	VARIABLE-LIST = (32,45) ..

HR-1 = HOURLY-REPORT
	REPORT-SCHEDULE = S-1
	REPORT-BLOCK = (RB-1) ..

-Jon


======================================================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM



======================================================
You received this e-mail because you are subscribed 
to the BLDG-SIM at GARD.COM mailing list.  To unsubscribe 
from this mailing list send a blank message to 
BLDG-SIM-UNSUBSCRIBE at GARD.COM