[BLDG-SIM] DOE 2.1E Hourly Report Question
Brahme, Rohini UTRC
BrahmeR at utrc.utc.com
Wed Nov 14 07:45:11 PST 2007
If you are using DOE2.1 e (not eQuest), the hourly report file gets
generated in the main doe2.1 folder - and it has a non-intuitive name
which I forget at this time and most probably the extension is .dat. The
reference manual explains this under the hourly reporting chapter.
-----Original Message-----
From: BLDG-SIM at gard.com [mailto:BLDG-SIM at gard.com] On Behalf Of Jon
Evans
Sent: Wednesday, November 14, 2007 10:15 AM
To: BLDG-SIM at gard.com
Subject: [BLDG-SIM] DOE 2.1E Hourly Report Question
I added the following code to a DOE 2.1E file to obtain the hourly
electric
(32) and gas consumption (45). The code was added in the systems block.
Where is the hourly report exported to? I was under the impression that
it
goes to the .sim file and would be called RB-1, but when I open that
file it
doesn't show up (the .sim file also gives me an out of memory message-
could
this be causing the problem?). Thanks for any insight in advance.
$=======================================$
$ Hourly Report Information
$=======================================$
S-1 = SCHEDULE
THRU DEC 31 (ALL) (1,24) VALUES = (1.) ..
RB-1 = REPORT-BLOCK
VARIABLE-TYPE = Alternate_1_RTU
VARIABLE-LIST = (32,45) ..
HR-1 = HOURLY-REPORT
REPORT-SCHEDULE = S-1
REPORT-BLOCK = (RB-1) ..
-Jon
======================================================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
===========================
You received this e-mail because you are subscribed
to the BLDG-SIM at GARD.COM mailing list. To unsubscribe
from this mailing list send a blank message to
BLDG-SIM-UNSUBSCRIBE at GARD.COM
More information about the Bldg-sim
mailing list