[Bldg-sim] Two Buildings - One Site

[Aulbach, John]

Ross:

I am sure that approach can be done. However, I have always found it
easier to do both towers in the Design Development Wizard. You can
switch from the Schematic to the DD Wizard in the menus.

You can then base your 2nd tower shell to copy the same level shell in
Tower 1. Then go to the first screen, in which you can say how many feet
and in which direction you wish this shell to be from the reference
shell. 

John R. Aulbach, PE, CEM
Project Manager
Nexant, Inc.
701 West Kimberly Ave., Suite 245
Placentia, CA 92870-6342 USA
Phone: 714-524-4402
Fax: 714-524-4407
email: jaulbach at nexant.com
 


-----Original Message-----
From: bldg-sim-bounces at lists.onebuilding.org
[mailto:bldg-sim-bounces at lists.onebuilding.org] On Behalf Of Ross
Vercillo
Sent: Monday, February 11, 2008 7:53 AM
To: Bldg-sim at lists.onebuilding.org
Subject: [Bldg-sim] Two Buildings - One Site

Hi,

I am simulating a twin towers site.  I have created the east and west
towers in different files through the 'Schematic Design Wizard'.

How can I combine these two files into one?

I was hoping somebody could either answer this question for me, or
direct me to a manual/literature where I would be able to find the
answer.

Thank you,

R. Vercillo

_______________________________________________
Bldg-sim mailing list
Bldg-sim at lists.onebuilding.org
http://lists.onebuilding.org/listinfo.cgi/bldg-sim-onebuilding.org