[Bldg-sim] eQuest GSHP

[Steve Mignogna]

Todd-

Are you trying to set up a centralized or decentralized GSHP?

-- 
Steve Mignogna
Atelier Ten

On Mon, Jun 16, 2008 at 4:36 PM, Todd Lagus <TLagus at sebesta.com> wrote:

>  Hello,
>
>
>
> I'm sure this has been addressed at some point, but does anyone have
> experience or tutorials in setting up ground source heat pump loops in
> eQuest?  I have been able to set up the ground source heat exchanger, but
> I'm unsure of the methods and limitations for linking the ground source loop
> to the water/water or water/air heat pump component.  Are both situations
> possible?  For an airside device, would I set up the ground loop, then set
> up the airside device and select the particular water source loop with which
> to link it?
>
>
>
> Thanks in advance for any advice.
>
>
>
> Todd
>
>
>
>
>
> *Todd Lagus, EIT*
>
> Mechanical Engineer
>
> *Sebesta Blomberg*
>
> *2381 Rosegate*
>
> *Roseville**, MN 55113*
>
> *Phone: 651-634-7236*
>
> *Fax: 651-634-7400*
>
> *www.sebesta.com*
>
>
>
> *This message has been sent via the Internet. Internet communications are
> not secure against interception or modification. Sebesta Blomberg therefore
> cannot guarantee that this message has not been modified in transit. This
> message and any files transmitted with it are confidential and intended
> solely for the use of the addressee. If you have received this message in
> error, please notify the sender and destroy your copies of the message and
> any attached files.*
>
>
>
> _______________________________________________
> Bldg-sim mailing list
> http://lists.onebuilding.org/listinfo.cgi/bldg-sim-onebuilding.org
> To unsubscribe from this mailing list send  a blank message to
> BLDG-SIM-UNSUBSCRIBE at ONEBUILDING.ORG
>
>


-- 
Steve Mignogna
Atelier Ten
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20080626/81f21711/attachment-0001.htm>