[Bldg-sim] EE4 Run Time Error

[Marc-Antoine Paquin]

Hi Alex,

 

These errors could be related to your assemblies (2 thermal bridges in the
same composition, layers with no width, etc.).

 

Another common error is related to the heavy floor, try to put them in
medium weight floor if it’s not the case.

 

A way figure out where the error is coming from is by sequentially deleting
your zones or spaces (after you have saved a copy of your .bld)  and see if
it comes from one the specific zone.  Otherwise, I think it would be related
to your assemblies.

 

Regards, 

 

 

Marc-Antoine Paquin, ing.

Directeur Service simulation

 

SignatureCouriel

 

________________________________ 
Le présent courrier électronique (courriel) et les documents qui y sont
attachés peuvent contenir de l'information confidentielle; ils s'adressent
exclusivement au(x) destinataire(s) mentionné(s) ci-dessus et nulle autre
personne ne doit en prendre connaissance ni les utiliser ou les divulguer.
Si vous recevez le présent courriel par erreur, veuillez en aviser
l'émetteur immédiatement par courrier électronique et le détruire avec les
documents qui y sont attachés.

The information contained in this e-mail and all attachments is confidential
and is for the sole use of its intended recipient. It may not be disclosed
to or used by anyone other than the addressee. If received in error, please
contact the sender by return e-mail and delete this e-mail and all
attachments from your system.

 

De : bldg-sim-bounces at lists.onebuilding.org
[mailto:bldg-sim-bounces at lists.onebuilding.org] De la part de Alex Blue
Envoyé : 26 mars 2012 13:29
À : bldg-sim at lists.onebuilding.org
Objet : [Bldg-sim] EE4 Run Time Error

 

I have built a model in EE4 (Canadian compliance software) and am getting
the error “A DOE run time error has occurred, therefore no results are
available.  Please check the BDL and SIM files created by DOE, and verify
your inputs.”

 

Trouble is, I get one warning but no errors in the BDL file.  I can’t see
anything obviously wrong with it, though at this stage I’m expecting quite a
few underheated hours.  Could that be causing this error?  

 

Any EE4 users have experience with this error, know of something obvious to
check, or have a good way to figure out where the error even is?

 

The building has a couple of DX single zone systems and a boiler/cooling
tower source hydronic heat pump loop.

 

Thanks for your help,

 

Alex Blue

  _____  

Aucun virus trouvé dans ce message.
Analyse effectuée par AVG - www.avg.fr
Version: 2012.0.1913 / Base de données virale: 2114/4895 - Date: 26/03/2012

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20120326/1882c340/attachment-0002.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image001.jpg
Type: image/jpeg
Size: 23590 bytes
Desc: not available
URL: <http://lists.onebuilding.org/pipermail/bldg-sim-onebuilding.org/attachments/20120326/1882c340/attachment-0002.jpg>