Cristina Castaño/LABEIN and others wrote:
1.-
The walls are not conneted and there is a gap between them.
From the
developer of the IFC to IDF app:
On point number 1:
The walls are not
connected for the reason that this user surmises. BSPro uses the centerline of
the wall to position each surface of zero thickness. This is not a problem for
the thermal calculations. It is potentially a problem for daylighting, but I do
not have current plans to change the approach used by BSPro.
A trick to eliminate this
problem:
I was facing the same problem and
found a way. When you draw in ArchiCAD/ ADT, you can use wall thickness of 0”/
0mm. You will get the output you are looking for.
For your
information, I have attached the .IFC and .IDF files with the email.
Regards
***************************************
Monjur M Mourshed
IRUSE
Informatics Research Unit for Sustainable
Engineering
Web: http://www.ecaad.com/monjur
http://www.ucc.ie/iruse/monjur
Email : m.mourshed@xxxxxxxxxxx
***************************************
| Yahoo! Groups Sponsor | |
|
|
To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.