[EnergyPlus_Support] More than one supply plenum

["kirbyschapman" <chapman@xxxxxxx>]

Hello, Folks.

I'm attempting to use four separate supply plenums. The caveat is 
that the first plenum serves a couple of zones, plus the second 
plenum. The second plenum serves one zone and the third plenum. 
Finally, the third plenum serves a final zone. 

In doing so, I used a splitter from Plenum 1 to feed the two zones 
and Plenum 2. Then another splitter from Plenum 2 to a zone and 
plenum 3.

This didn't work, and in fact the program crashed (I only ran it 
with the first two zones). 

Is this the correct way to tackle a situation like this?

Thanks much

Kirby


------------------------ Yahoo! Groups Sponsor ---------------------~-->
Buy Ink Cartridges or Refill Kits for Your HP, Epson, Canon or Lexmark
Printer at Myinks.com. Free s/h on orders $50 or more to the US & Canada. http://www.c1tracking.com/l.asp?cid=5511
http://us.click.yahoo.com/l.m7sD/LIdGAA/qnsNAA/dkFolB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files are of the Support Web Site.




 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/