[EnergyPlus_Support] Sensible Heating and Cooling Loads

[Peter G Loutzenhiser <post@xxxxxxxxxxx>]

All,
I have built a simulation and when I run it I get both zone sensible 
heating and cooling rates during the same hours.  I am using Normal Damper 
Heating Action, but when I look at my zone output, I have mass flow rates 
above the minimum specified fraction.  I then look at my "Total water 
heating coil rate" I am still transferring heat into the air stream, which 
seems very odd.  Has anyone run into to similar problems, and is there a 
remedy?  Thanks.



Best Regards,

Peter Loutzenhiser
post@xxxxxxxxxxx
PhD Student
Mechanical Engineering
Iowa State University
Office: 515-294-0365 



------------------------ Yahoo! Groups Sponsor ---------------------~-->
Buy Ink Cartridges or Refill Kits for your HP, Epson, Canon or Lexmark
Printer at MyInks.com. Free s/h on orders $50 or more to the US & Canada.
http://www.c1tracking.com/l.asp?cid=5511
http://us.click.yahoo.com/mOAaAA/3exGAA/qnsNAA/dkFolB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files are of the Support Web Site.




 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/