[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] COMIS CP Array

""only one COMIS CP Array object should be specified""

this allows for CP values to be entered only for ONE reference height (eg. defalut 10M). i am attempting to simulate a 5-story rectangular building and i have the wind pressure coefficient data for all the levels, i.e level 1 to level 5 - 0 thru 270 degrees.

how do i go about this? 

some thoughts: COMIS External Node defines environmental conditions outside of the building - if we could set the height for these nodes then maybe i could have a node at every level for each facade and now if i defined the CP values for the NODEs it would automaically read it for that level. BUT we cannot set the height of the NODE - only associate it to a facade (eg. N, S, E, W Facades)... correct...?

am i missing something here?

thank you.


PS: i could send you the .dxf file to look at

Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing

[Non-text portions of this message have been removed]

------------------------ Yahoo! Groups Sponsor ---------------------~-->
Buy Ink Cartridges or Refill Kits for your HP, Epson, Canon or Lexmark
Printer at MyInks.com. Free s/h on orders $50 or more to the US & Canada.

To unsubscribe from this group, send an email to:

The primary EnergyPlus web site is found at:

The group web site is:

Attachments are not allowed -- please post any files to the appropriate folder in the Files are of the Support Web Site.


Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/