[EnergyPlus_Support] report

["David Cormier" <dcormier81@xxxxxxxxxxx>]

Hello,

I do a simple test with EnergyPlus.  It's about a simple room with no 
internal load.  I look at the result

If I add : ZONE1:Zone Window Heat Gain[W](Hourly) + MUR1:Opaque Surface 
Inside Face Conduction Loss[W](Hourly) or gain for my wall + TOIT:Opaque 
Surface Inside Face Conduction Loss[W](Hourly) or gain

I think that I suppose to have the same result as ZONE1:Zone/Sys Sensible 
Load Predicted[W](Hourly).  In heating, its ok, but in cooling, I have a 
mistake because the result of the add is always higher than the result of 
ZONE1:Zone/Sys Sensible Load Predicted[W]

I suppose that I forget a term in the add ... Do you have an idea?

David Cormier

_________________________________________________________________
MSN Messenger : discutez en direct avec vos amis !  
http://messenger.fr.msn.ca/



The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files are of the Support Web Site.




 -- please post any files to the appropriate folder in the Files are of the Support Web Site.




 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
     EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/