Re: [EnergyPlus_Support] Two questions on surface heat transfer

["Alberto Hernandez Neto" <ahneto@xxxxxx>]

Dear Sir,

You can divide your wall1l in two halves with the same layers and construction, one facing zone 2 and the other facing zone 3.
Regarding the zone origin problem, I work with E+ in similr and it was OK. E+ will give a warning that some of the zone aren´t in the (0,0,0) but it will simulate properly.

Sincerely,

Alberto Hernandez Neto

  ----- Original Message ----- 
  From: pizzaalan 
  To: EnergyPlus_Support@xxxxxxxxxxxxxxx 
  Sent: Monday, May 03, 2004 11:30 PM
  Subject: [EnergyPlus_Support] Two questions on surface heat transfer


  I had two questons on surface heat transfer. 

  First, I have a zone plan like below,

  ---------------------
  |                   |
  |                   |
  | Zone 1            |
  |                   |
  |     Wall 11       |
  ---------------------
  | wall21 | Wall31   |
  |        |          |
  | Zone 2 | Zone 3   |
  |        |          |
  ---------------------
  (0,0,0)  (10,0,0)   (20,0,0)
       South 

  The problem is when I tried to specify the "outside  face 
  environment object" of wall 11 at zone1, it should be both wall 21 
  of zone2 and wall 31 of zone3. How can I input both of them?

  Secondly, if I use relative coordinate system, all of zone origins 
  should be (0,0,0), and then the south exterior wall of zone 3 should 
  be described as (10,0,0), (20,0,0), (20,0,3) and (20,0,3). Is it 
  right? 

  Thank you in advance and have a nice day!

  Alan
  Sincerely,






  The primary EnergyPlus web site is found at:
  http://www.energyplus.gov

  The group web site is:
  http://groups.yahoo.com/group/EnergyPlus_Support/

  Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.



        Yahoo! Groups Sponsor 
              ADVERTISEMENT
             
       
       


------------------------------------------------------------------------------
  Yahoo! Groups Links

    a.. To visit your group on the web, go to:
    http://groups.yahoo.com/group/EnergyPlus_Support/
      
    b.. To unsubscribe from this group, send an email to:
    EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx
      
    c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 



[Non-text portions of this message have been removed]



The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
     EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/