[EnergyPlus_Support] Dedicated Outdoor Air System

["liao_lucia" <liao@xxxxxxxxxxx>]

I simulated the performance of an Dedicated Outdoor Air System 
(which includes enthalpy wheel, desiccant wheel, water coil, 
microturbine...) in EES. Therefore I can get the theoretical curves 
of its supply air temperature (T) and humidity (RH), i.e. the 
leaving supply air conditions are known if the entering outdoor air 
conditions are given.

Assume the DOAS and other HVAC units are installed in a building, 
and Energy+ is used to simulate the performance. Is there any method 
to plug the DOAS curves of T and RH obtained from other software, 
such as EES, into Energy+ ? Therefore, I can avoid modeling the 
complicate DOAS inside Energy+, and just use the results from EES  
instead.

Thanks !

Lucia



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/dkFolB/TM
--------------------------------------------------------------------~-> 

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
     EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/