[EnergyPlus_Support] max itetation problem

["pizzaalan" <pizzaalan@xxxxxxxxx>]

I try to simulate a building with VAV single duct reheat system, and 
I use ¡°5ZoneAuto.idf¡± as example. I gave the exactly same system 
to my building and run it at Minneapolis, except that there is no 
plenum zone in my building.

However, I always get  ¡°** Warning ** SimHVAC: Maximum iterations 
exceeded for all HVAC loops, MINNEAPOLIS SUMMER¡±. 

I am sure there is no problem on control setpoints, schedules, 
active or passive braches because I just copied from the 5AutoZone.  
Since I used autosizing, there is no possibility that sum of 
terminal airflows is not equal to supply fan air flow.  I double 
checked all the air loop and water loop connections. It should be Ok 
if I understand correctly.

I don¡¯t know where else it might be wrong.  I attach the idf 
file "MySingleDuctReheatwithEconomizer2 "and appreciate if someone 
could help me have a look the file. Thank you so much.

Meng



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/dkFolB/TM
--------------------------------------------------------------------~-> 

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
     EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/