[EnergyPlus_Support] Lo Temp Radiant Hydronic outputs

["sm278424" <shaunmartin@xxxxxxx>]

E+ provides

 Maximum cold water flow [m3/s]
 Hydronic tubing length [m]

as outputs from the Lo Temp Radiant Hydronic component.

1. In a ceiling panel configuration, these two values seem to produce 
a total panel area that is about 20% larger than the manufacturers 
(Sterling, in particular) indicate. It would be an expensive 
difference.  Can anyone comment on this?

2. What are the input parameters that have the biggest impact? The 
inlet water temperature (from the 'cooling control temperature 
schedule') doesn't seem to have much effect.

I've set the radiant system to have priority over the VAV:Reheat. 

Thanks for any comments,
Shaun




------------------------ Yahoo! Groups Sponsor --------------------~--> 
Make a clean sweep of pop-up ads. Yahoo! Companion Toolbar.
Now with Pop-Up Blocker. Get it for free!
http://us.click.yahoo.com/L5YrjA/eSIIAA/yQLSAA/dkFolB/TM
--------------------------------------------------------------------~-> 

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
    EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/