[EnergyPlus_Support] Set point not met

["dust_broom" <necas@xxxxxxxxxxx>]

Dear all. 

I've simulated a cooling system for a 4 zone bilding using a chiller a 
boiler(for reheat), coils and a single duct . Every component was 
suposed to be autosized. So I did the autosize. But than, in the 
results I saw that only one of the four zones had its temperature 
correct. the others were floating arround 6 degrees. Even in the 
design day simulation some zones were too hot. shouldn't the design 
day be sizing those equipments in order to maintain the zone 
temperatura as specified? Am I doing anything wrong?

Thank you, Emanuel





------------------------ Yahoo! Groups Sponsor --------------------~--> 
1.2 million kids a year are victims of human trafficking. Stop slavery.
http://us.click.yahoo.com/WpTY2A/izNLAA/yQLSAA/dkFolB/TM
--------------------------------------------------------------------~-> 

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.idf and press the "search" button.
 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/EnergyPlus_Support/

<*> To unsubscribe from this group, send an email to:
    EnergyPlus_Support-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/