It looks like it failed in the input processor (Fatal: " IP "). This
would be before the error file is created. See if there is an audit file
(eplusout.audit) that you can look at. I am not sure if you will find
the error at the end of this file, or somewhere in the
middle.
xing.shi.2006 wrote:
>
>
> When using
EP-Launch, there is no error in the ERR file. 0 Warning, 0
> Severe
errors.
>
> When using DOS mode to run the same IDF file, it did
not yield ERR
> file. I think the program just stopped somewhere before
the ERR file
> was produced.
>
> It might be caused by the
IDF file because I tried another IDF file
> and it ran just fine in both
DOS mode and EP-Launch. The thing I
> don't understand is that the same
IDF file runs ok in EP-Lauch but not
> in "runeplus 1 1" mode.
>
> XS
>
>
--
Richard A. Raustad
Senior Research
Engineer
Florida Solar Energy Center
University of Central Florida
1679
Clearlake Road
Cocoa, FL 32922-5703
Phone: (321) 638-1454
Fax: (321)
638-1439 or 1010
Visit our web site at: http://www.fsec.ucf.edu
UCF -