In my project, i have a large area of an office building non divided by partitions and i need to simulate a VAV, due to very diferent loads.
To divide the zones, i created 8 zones, due to the facility to install the vav on the already done ducts.
What im getting trouble is how to set the interzone surface. In energyplus, the surfaces always need a construction, but my interzone surfaces in fact do not have any contruction dividing them, the air is free the to cross the zones. How can i set up this on EP? Thanks in advance
Novo Internet Explorer 8: faça tudo com menos cliques. Baixe agora, é gratis!
__._,_.___
The primary EnergyPlus web site is found at:
http://www.energyplus.gov
The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/
Attachments are not allowed -- please post any files to the appropriate folder in the Files area of the Support Web Site.
EnergyPlus Documentation is searchable. Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe
__,_._,___