[EnergyPlus_Support] How to get around needing to have zone Infiltration

["Morss, Greg" <gmorss@xxxxxxxx>]

Hello,

 

I am trying to model a floor of a hospital, which is positively pressurized, so there should be Zero infiltration.  However when I try running the model by either setting the infiltration to zero or by removing the ZoneInfiltration objects I start getting mass amounts of this warning:

 

** Warning ** SimHVAC: Maximum iterations (20) exceeded for all HVAC loops, at NORMAL, 01/01 12:00 - 12:15

 

Even if I change the iterations to a higher number (100) I still get issues.  Anyone have a work around for this?

 

Thanks

 

Greg

__._,_.___

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___