[EnergyPlus_Support] Zone Exhaust Fan error

[Vinay Devanathan <vinay.devanathan@xxxxxxxxx>]

I am using EnergyPlus to model a building. I included Zone exhaust fans in the model. But,
 when I auto-size the model with this Zone Exhaust Fan object, I get a 
warning message saying - 

**   ~~~   **   there is unbalanced exhaust air flow. 
**   ~~~  
 **   Unless there is balancing infiltration / ventilation air flow, 
this will result in
**   ~~~   **   load due to induced outdoor air 
being neglected in the simulation.

And, I think the design loads are increased due to this, which would
 probably cause over-sizing. 

Any help in solving this issue 
would be greatly appreciated. 

Thank you.

Regards,
Vinay

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___