[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[EnergyPlus_Support] Building Total Area Changes in Reports





I am experiencing changes in zone/ building square footages in a model developed in SketchUp Pro. The zones display the correct square footage in SketchUp but when the simulation is run and the reports are generated, 50% of the zones show an increase in area ranging from 25% to 259% with no discernable pattern. The remaining zones display correctly. When I copy the surface details of an affected zone from the idf to a new file and open it in SketchUp, the zone is drawn with the correct area. I have no multipliers in the .idf. What else should I check? Thank you.



__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.




Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___