[EnergyPlus_Support] microCHP

[George <gounphysic@xxxxxxxx>]

Hi to everyone.

I am using a Generator micro CHP as a replacement of a boiler for a domestic heat.

firstly I create an idf model for a house with baseboard heating radiators feed up from a boiler. The model run successfully and i get very realistic results.

The next step was to replace the boiler unit with a micro CHP in order to make a comparison.

The simulation run again successfully but when i try to obtain results as the gas consumption of the CHP unit the results was simple zero. meaning that the unit dose not work.

I used the drawing tool which shown that the only change was just the replacement of the boiler to a chp.

Has any of you use the CHP model for domestic use cause i don't know what to check.

Thanks 

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___