[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [EnergyPlus_Support]



Hi,
In my opinion your zone modeling has problem. when your floor and ceiling material construction are not symmetric you can not model more than one floor in a zone (Output/Input pdf page  213)
REZA

On Mon, Dec 6, 2010 at 7:23 AM, Rohit Kadam <rohitkadamis@xxxxxxxxxxx> wrote:
 

Dear All,


I constructed a six floored building with 2 zones. One zone for basement as it is underground and the other zone for all above floors. I am getting fatal error as below,  I have an important paper due soon, I have been trying to create this building model since 2 months now. I have attached my idf file if you could please go through it. I did enter appropriate boundary condition as ground for basement still I am getting the error. So if you could please help me solve this error. thank You.

 
** Warning ** CalcSurfaceCentroid: 1 Surfaces have the Z coordinate < 0.
   **   ~~~   ** ...in any calculations, Wind Speed will be 0.0 for these surfaces.
   **   ~~~   ** ...in any calculations, Outside temperatures will be the outside temperature + 9.750E-003 for these surfaces.
   **   ~~~   ** ...that is, these surfaces will have conditions as though at ground level.
   **  Fatal  ** Fatal error discovered in GetSurfaceData, see previous messages

attached is the idf file and error file
  

 Thank You
Regards
Rohit 




__._,_.___


Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.



Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___