** Warning ** GetSpecificHeatGlycol: Temperature is out of range (too low) for glycol specific heat **
** ~~~ ** ..Called From:CalcHPCoolingSimple:SourceSideInletTemp Glycol=WATER,Temperature=-10.50
** ~~~ ** Environment=WATERTOWN AP ANN HTG 99.6% CONDNS DB, at Simulation time=01/21 00:00 - 00:15
** Warning ** Check GLHE design inputs & g-functions for consistency
** ~~~ ** For GroundHeatExchanger:Vertical VERTICAL GROUND HEAT EXCHANGERGLHE delta Temp > 100C.
** ~~~ ** This can be encountered in cases where the GLHE mass flow rate is either significantly
** ~~~ ** lower than the design value, or cases where the mass flow rate rapidly changes.
** ~~~ ** Glhe Current Flow Rate=0.329; Glhe Design Flow Rate=0.329
-----------------
Is there anything that I am doing wrong causes this error? Any possible fix?
Hope to hear from someone.
Thank you.