Has anyone come across this error before?
** Warning ** GetSpecificHeatGlycol: Temperature is out of range (too low) for glycol specific heat **** ~~~ ** ..Called From:CalcHPCoolingSimple:SourceSideInletTemp Glycol=WATER,Temperature=-10.50** ~~~ ** Environment=WATERTOWN AP ANN HTG 99.6% CONDNS DB, at Simulation time=01/21 00:00 - 00:15** Warning ** Check GLHE design inputs & g-functions for consistency** ~~~ ** For GroundHeatExchanger:Vertical VERTICAL GROUND HEAT EXCHANGERGLHE delta Temp > 100C.** ~~~ ** This can be encountered in cases where the GLHE mass flow rate is either significantly** ~~~ ** lower than the design value, or cases where the mass flow rate rapidly changes.** ~~~ ** Glhe Current Flow Rate=0.329; Glhe Design Flow Rate=0.329-----------------Is there anything that I am doing wrong causes this error? Any possible fix?Hope to hear from someone.Thank you.