Re: [EnergyPlus_Support] Setpoint for LowTemperatureRadiating:ConstantFlow ?

[Karen Walkerman <kwalkerman@xxxxxxxxx>]

You could try an AvailabilityManager.  It looks like AvailabilityManager:LowTemperatureTurnOff might work for you.  Don't forget to create the AvailabilityManager:AssignmentList object, AND to specify the AvailabilityManager:AssignmentList in the Loop syntax.

--

Karen 

On Sat, Apr 30, 2011 at 4:47 PM, Geert Bellens <geert.bellens@xxxxxxxxxxxxxxxxxxxxxx> wrote:

 

I've made a model with designbuilder, and a VAV is serving ventilation and some of the necessary heating and cooling.

I'm now modeling concrete core cooling (and heating) in E+ with the LowTemperatureRadiating:ConstantFlow object.

The temp° of the water is regulated by the outdoor temp°. So far so good.

I can schedule the pump and the object, if I want (but not necessary, it's a continuous system).

The temperature of the zone with the concrete cooling/heating is working fine, but...

Can I put somewhere a setpoint to prevent the interior temperature to become to high (or to low)caused by the lowtempradiating object ?
This means the pump, or the object needs to stop working (for that zone) based on the operating temperature inside ?

Geert

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___