Re: [EnergyPlus_Support] Default zone loads in Openstudio

[Linda Lawrie <linda@xxxxxxxxxxxxxx>]

Sounds like a question to ask the OpenStudio forum.

At 11:27 AM 6/16/2011, Rohit Kadam wrote:


> Hi all,
>
>  I am using OpenStudio to create a building model and then run it in
> EnergyPlus. For applying the zone loads I used the Default office option
> in OpenStudio but I have certain questions in the loads like for
> winter design day the lighting and equipment load was 0
> "zero" for all 24 hours in default office selection. I don't
> understand why these loads are zero in winter.
>
> Also I need to know how are the loads in default office allotted (i.e.
> the calculation for that).
>
>  Thank you
> regards
> Rohit

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___