Re: [EnergyPlus_Support] Default zone loads in Openstudio

[Ricciano Liberari <ricciano@xxxxxxxxxxxxx>]

The lighting and equipment loads are zero because this is the worse scenario to heating (HVAC). And you should model the HVAC to this scenario.

Ricciano.

2011/6/16 Linda Lawrie <linda@xxxxxxxxxxxxxx>

 

Sounds like a question to ask the OpenStudio forum.

At 11:27 AM 6/16/2011, Rohit Kadam wrote:

Hi all,

 I am using OpenStudio to create a building model and then run it in EnergyPlus. For applying the zone loads I used the Default office option in OpenStudio but I have certain questions in the loads like for winter design day the lighting and equipment load was 0 "zero" for all 24 hours in default office selection. I don't understand why these loads are zero in winter.

Also I need to know how are the loads in default office allotted (i.e. the calculation for that).

 Thank you
regards
Rohit

--

Att,

--
Ricciano Liberali

 

Cel:55 51 81281500

www.petinelli.com

Petinelli Inc.
A Green Building Solutions Company
Rua General Carneiro 638, Alto da Gloria
Curitiba - PR  80060-150  BRAZIL

__._,_.___

Primary EnergyPlus support is found at:
http://energyplus.helpserve.com or send a message to energyplus-support@xxxxxxxx

The primary EnergyPlus web site is found at:
http://www.energyplus.gov

The group web site is:
http://groups.yahoo.com/group/EnergyPlus_Support/

Attachments are currently allowed but be mindful that not everyone has a high speed connection.  Limit attachments to small files.

EnergyPlus Documentation is searchable.  Open EPlusMainMenu.pdf under the Documentation link and press the "search" button.

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: Switch delivery to Daily Digest | Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | Unsubscribe

__,_._,___